G Pen Micro - Watch this before you buy the G Pen Micro Vaporizer Pen G
- 10 năm trước
http://www.rastavapes.com G Pen Micro is overpriced! Check out our g pen vaporizer from rasta vapes! Our G pen is Micro in size, but not power!
Afterburner G Pen Portable Pen Vaporizer Manual:
1. Fully Charge your Vaporizer Device Before the first use
2. Press the button 3 times in rapid succession to Lock or Unlock.
3. Flashing of time out : 5 Times
4. Flashing of Low battery : 20 times
5. Equipped with a High-capacity battery for 1 to 2 days of continuous use
6. It has a built in safety feature That will temporarily deactivate the atomizer after 10 seconds of continuous atomization.
7. TO USE: After initial charge, pack your G Pen Vape, press button and start vaping in seconds. Enjoy!
Charging your Afterburner G Pen Vape:
Once unpackaged, your Afterburner G Pens battery will have a small charge. For the best performance, it's recommended that you charge your battery fully no longer than 30-40min before using. To charge the Afterburner G Pen, plug your wall charger into the outlet, then the other end into the bottom of your battery. A red LED light on the bottom of the battery will light up to show that the battery is charging.
When the battery is completed charging the red LED light will turn off, signifying the battery is completely charged and can be disconnected from the charger. If after 30-40 minutes the light does not turn off, don't worry just unplug and start using.
We recommend avoiding overcharging the G Pen since it may significantly shorten battery life. Overcharging it over night or over an hour is not recommended!
DO NOT LEAVE YOUR BATTERY CONNECTED TO YOUR CHARGER FOR EXTENDED PERIODS OF TIME ONCE CHARGING IS COMPLETE, AS THE BATTERY WILL BEGIN TO DRAIN OVER TIME.
During general use the G Pen battery will inform you when it needs charging when the blue G Pen button's LED illuminates for 5 seconds, then blinks 3 times.
G Pen Atomizer
Usage:
Before use or loading, press and hold your G Pen button for a minimum of ten seconds to break the atomizer in.
Never overload your atomizer - Only a small amount of your product is recommended. Overloading the atomizer can shorten the life of your atomizer.
Never make direct contact with the heating coil.
Maintenance:
Cleaning is necessary to preserve the atomizer. When cleaning the G Pen remove the mouthpiece from the atomizer. Turn the G Pen upside down and hold the AfterBurner G Pen Vape button removing any of your remaining product into a salvageable container or into a heat safe trash dish. Shake out any remaining product into desired receptacle, thus clearing out the atomizer. Remove the atomizer from the battery. Clean the G Pen atomizer using a cotton swab and rubbing alcohol from the inside or exterior of the atomizer. A cotton swab may also be used to clean within the mouthpiece as well.
Afterburner G Pen Portable Pen Vaporizer Manual:
1. Fully Charge your Vaporizer Device Before the first use
2. Press the button 3 times in rapid succession to Lock or Unlock.
3. Flashing of time out : 5 Times
4. Flashing of Low battery : 20 times
5. Equipped with a High-capacity battery for 1 to 2 days of continuous use
6. It has a built in safety feature That will temporarily deactivate the atomizer after 10 seconds of continuous atomization.
7. TO USE: After initial charge, pack your G Pen Vape, press button and start vaping in seconds. Enjoy!
Charging your Afterburner G Pen Vape:
Once unpackaged, your Afterburner G Pens battery will have a small charge. For the best performance, it's recommended that you charge your battery fully no longer than 30-40min before using. To charge the Afterburner G Pen, plug your wall charger into the outlet, then the other end into the bottom of your battery. A red LED light on the bottom of the battery will light up to show that the battery is charging.
When the battery is completed charging the red LED light will turn off, signifying the battery is completely charged and can be disconnected from the charger. If after 30-40 minutes the light does not turn off, don't worry just unplug and start using.
We recommend avoiding overcharging the G Pen since it may significantly shorten battery life. Overcharging it over night or over an hour is not recommended!
DO NOT LEAVE YOUR BATTERY CONNECTED TO YOUR CHARGER FOR EXTENDED PERIODS OF TIME ONCE CHARGING IS COMPLETE, AS THE BATTERY WILL BEGIN TO DRAIN OVER TIME.
During general use the G Pen battery will inform you when it needs charging when the blue G Pen button's LED illuminates for 5 seconds, then blinks 3 times.
G Pen Atomizer
Usage:
Before use or loading, press and hold your G Pen button for a minimum of ten seconds to break the atomizer in.
Never overload your atomizer - Only a small amount of your product is recommended. Overloading the atomizer can shorten the life of your atomizer.
Never make direct contact with the heating coil.
Maintenance:
Cleaning is necessary to preserve the atomizer. When cleaning the G Pen remove the mouthpiece from the atomizer. Turn the G Pen upside down and hold the AfterBurner G Pen Vape button removing any of your remaining product into a salvageable container or into a heat safe trash dish. Shake out any remaining product into desired receptacle, thus clearing out the atomizer. Remove the atomizer from the battery. Clean the G Pen atomizer using a cotton swab and rubbing alcohol from the inside or exterior of the atomizer. A cotton swab may also be used to clean within the mouthpiece as well.